![]() ![]() The standards for aerial lifts have been relocated from. Overhand bricklaying - A guardrail or personal fall arrest system on all sides except the side where the work is being done must protect employees doing overhand bricklaying from supported scaffolds.Inspections - Before each work shift and after any occurrence that could affect the structural integrity, a competent person must inspect the scaffold and scaffold components for visible defects.Training - Employers must train each employee who works on a scaffold on the procedures to control or minimize the hazards.Erecting and Dismantling - When erecting and dismantling supported scaffolds, a competent person must determine the feasibility of providing a safe means of access and fall protection for these operations.When the crosspoint of crossbracing is used as a toprail, it must be between 38 inches (0.97 m) and 48 inches (1.3 m) above the work platform. Midrails must be installed approximately halfway between the toprail and the platform surface. The height of the toprail for scaffolds manufactured and placed in service after Janumust be between 38 inches (0.97 m) and 45 inches (1.2 m). The height of the toprail for scaffolds manufactured and placed in service before Janucan be between 36 inches (0.9 m) and 45 inches (1.2 m).The standard requires fall protection at a 10 foot height above a lower level for employees.The language of the rule has been simplified by eliminating duplicative and outdated provisions, consolidating overlapping requirements, and enhancing performance-based criteria to allow employers more flexibility in compliance while still protecting employees.Įmployers and employees should be familiar with seven key provisions of the revised scaffolding standard: In addition, it allows employers more flexibility when using protective systems for workers on scaffolding. The new final rule addresses training and various types of scaffolds, as well as falling object protection, ladders, weather conditions, aerial lifts, stilts, and other matters that were not previously covered by the OSHA scaffold standards. The new standards set performance-based criteria to protect employees from scaffold-related hazards such as falls, failing objects, structural instability, electrocution, or overloading. ![]() The final rule updates the existing construction scaffold standards in Subpart L. The revised standard, known as "Safety Standards for Scaffolds Used in the Construction Industry," is found in Title 29 Code of Federal Regulations (CFR) Part 1926, Subpart L. On August 30, 1996, OSHA issued revised standards for scaffolds. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |